Toro ProLine 30334 - Install Handles; Install Control Rods

15
4
Rear View
1
m–5458
4
3
2
2
Figure 5
1. Shift lever, 2nd gear
2. Control panel
3. Shift lever, neutral
4. Equal distance
Install Handles
1. Align handle with upper mounting hole in rear frame
(Fig. 6).
2. Secure each upper mounting hole with a flange bolt
(3/8 x 1 in. (26 mm)) and flange nut (Fig. 6).
3. Select low, middle or high position for the lower
mounting hole (Fig. 6). This allows the upper handle to
be adjusted to the user’s height preference.
4. Secure each lower mounting hole with a flange bolt
(3/8 x 1 in. (26 mm)) and flange nut (Fig. 6).
5. Repeat procedures for opposite handle.
Note: If handle position is ever changed, the control rods
and brakes will need to be readjusted.
m–5382
3
2
1
4
5
6
7
9
8
Figure 6
1. Handle
2. Rear frame
3. Flange bolt, 3/8 x 1 in.
(26 mm)
4. Flange nut, 3/8 in.
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. Middle position
9. High position
Install Control Rods
1. Thread rod fittings equal distance onto each control rod
(Fig. 7).
2. Install rod fittings with clevis pins into holes in idler
brackets (Fig. 7). Secure with washers and hairpin
cotters (Fig. 7).
Note: Install rod fittings so the clevis pin is above the
control rod, as shown in figure 7.
m–5385
6
4
3
5
1
2
Figure 7
1. Control rod
2. Idler bracket
3. Hairpin cotter
4. Clevis pin
5. Washer
6. Rod fitting