Toro ProLine 30334 - Adjusting Center Gage Wheels

22
2. Select a hole position so the gage wheels are a
minimum of 3/8 in. (9.5 mm) off the ground for the
height-of-cut to be used (Fig. 18).
3. Reinstall the stud nut and washer (Fig. 18).
4. Repeat adjustment on other gage wheels.
1
2
3
4
5
m–5201
Figure 18
1. Gage Wheel
2. Stud
3. Washer
4. Nut
5. Wheel nut and washer.
Do Not Remove.
Adjusting Center Gage Wheels
The gage wheels must be adjusted in the proper hole
location for each height-of-cut position.
1. After adjusting height-of-cut remove bolt, washers and
nut (Fig. 19).
2. Select a hole position so the gage wheels are a
minimum of 3/8 in. (9.5 mm) off the ground for the
height-of-cut to be used (Fig. 19).
3. Reinstall the bolt, washers and nut (Fig. 19).
1
2
3
m–5200
4
4
Figure 19
1. Center Gage Wheels and
Spacer
2. Nut
3. Bolt
4. Washer