Toro Recycler 20017 - Adjusting Mower Settings; Adjusting Cutting Height; Adjusting Handle Height

Adjusting the Cutting Height
If the engine has been running, the muffler will be hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height
as desired. Set all four
wheels to the same
height.
Note: To raise the mower,
move all 4 cutting height
levers forward; to lower
the mower, move them all
rearward.
m-5629
1-1/4"
_ 2-3/8" 3-1/8" "'_' 4-1/4"
1-5/8" 3-7/8"
:......................... /.....
FRONT _ _''
m-5605a
Adjusting the Handle Height
Squeeze the bottom of
the handle halves
together (as shown) and
change the handle holes
in which the pins (A) are
mounted, as follows:
• Raise the handle
using hole (B).
• Lower the handle
using hole (0).
B C
// /
/'
m-5614
//// m-5612
3352-565 Rev A