7
Operation
Starting the Engine
1. Firmly push in the primer 3 times with your
thumb, holding the primer in for a second before
releasing it each time.
Note: If the air temperature is below 55°F (13°C),
firmly push the primer in 5 times.
2. Hold the blade
control bar (A) against
the handle.
3. Start the engine using the recoil starter.
J /
/
/
Using the Self-propel Drive
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace
with you.
// /
/
/
/
/
//i /
m-5582
_f:?:::\,,
m-5613
Stopping the Engine
To stop the engine, release the blade control bar.
important: When you release the blade control bar,
both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.
//////' m-5606
4. If the mower does not start in 1 or 2 pulls, press
the primer button 1 or 2 times and try starting it again.
Note: If the mower still does not start, contact an
Authorized Service Dealer.
/
i /
Y_J
/ i
/ /
t/
m-5582
3352-565 Rev A
To Next Page
Loading...
