Toro Reelmaster
4000?D - Chapter 7 Cutting Units

Reelmaster 4000−D Page 7 − 1 Cutting Units
Chapter 7
Cutting Units
Table of Contents
SPECIFICATIONS 2. . . . . . . . . . . . . . . . . . . . . . . . . . . .
SPECIAL TOOLS 3. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ADJUSTMENTS 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Adjust Reel to Bedknife Contact 4. . . . . . . . . . . . . . .
Adjust Height−of−Cut (Floating Cutting Unit) 5. . . .
Quick Method for Changing Height−of−Cut
After Initial Set Up of a Floating Cutting Unit 6. .
Adjust Height−of−Cut (Fixed Cutting Unit) 7. . . . . .
Adjust Skids and Front Roller
(Fixed Cutting Unit) 7. . . . . . . . . . . . . . . . . . . . . . . .
SERVICE AND REPAIRS 8. . . . . . . . . . . . . . . . . . . . . .
Backlapping 8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Hydraulic Motor Installation 9. . . . . . . . . . . . . . . . . . .
Bedknife/Bedbar 10. . . . . . . . . . . . . . . . . . . . . . . . . . .
Reel 11. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Preparing a Reel for Grinding 14. . . . . . . . . . . . . . . .
Front and Rear Rollers 15. . . . . . . . . . . . . . . . . . . . . .
Roller Bearing Replacement 16. . . . . . . . . . . . . . . . .
Lubrication 18. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cutting Units