Reelmaster 4000−D Page 4 − 43 Hydraulic System
13. Remove quad ring seal from seal gland bushing.
14. Use a thin−blade screwdriver to pry dust seal from
seal gland bushing. Do not damage bushing.
15. Remove 2 bearing races and the needle thrust bear-
ing from spool and sleeve assembly.
16. Remove spool and sleeve assembly from 14−hole
end of housing, see Fig. 34.
IMPORTANT: Do not bind spool and sleeve in hou-
sing. Rotate spool and sleeve assembly slowly
when removing from housing.
17. Push pin from spool and sleeve assembly.
Figure 32
Figure 33
Figure 34
Hydraulic
System
To Next Page
Loading...
