Toro Sand Pro 5040 - Installing Lift Valve (Model 08745)

5
InstallingtheLiftValve
Model08745Only
Partsneededforthisprocedure:
2
StraighthydraulicttingwithO-ring
2
90°hydraulicttingwithO-ring
1
Liftvalve
1Valveplate
3
Bolt(1/4x3inches)
3
Locknut(1/4inch)
2
Bolt(#10x1-1/4inches)
2
Locknut(#10)
1
Liftlever
Procedure
1.Threada90°ttingintotheexistingliftvalve
wheretheT-ttingwasremoved.
Important:Tightenonlythestraightttings
atthistime.EnsurethatallO-ringsare
lubricatedandproperlypositionedonthe
ttingsbeforeinstallation.
g362424
Figure9
1.Straighttting3.Liftvalve
2.90°tting4.T-tting
2.Installtheexistingliftvalvewiththepreviously
removedhardwareandtorquethefastenersto
10to12N∙m(90to110in-lb).
3.Threada90°tting,the2straighthydraulic
ttings,andtheT-ttingremovedfromthe
existingvalvein3PreparingtoInstallthe
HydraulicComponents(page4)intothenewlift
valveasshowninFigure9.
4.Mountthevalveassembly,pivotbracket,and
valveplatetotheframewith3bolts(1/4x3
inches)and3locknuts(Figure10).Positionthe
valveplateagainstthefrontoftheframemember
whenmounting,andtorquethefastenersto10
to12N∙m(90to110in-lb).
Note:Thevalveinstallationisverysimilarto
thevalvecurrentlyinstalled.
5.Looselymountthepivotleverassemblytothe
valvespoolandtotheoffsetlinkwith2bolts
(#10x1-1/4inch)and2locknuts(Figure10).
Note:Donottightenthefastenersatthistime.
g362425
Figure10
1.Valveassembly
4.Offsetlink
2.Pivotbracket5.Pivot
3.Valveplate6.Lever
7