Form No. 3465-943 Rev A
Jack Mount Kit
T imeCutter
®
Riding Mower
Model No. 147-8836
Installation Instructions
Safety
Safety and Instructional
Decals
Safety decals and instructions are
easily visible to the operator and are
located near any area of potential
danger . Replace any decal that is
damaged or missing.
decal127-6663
127-6663
1. W arning—read the
Operator's Manual .
2. Crushing hazard—engage
the parking brake, shut of f
the engine, and remove
the key; support the
machine using jackstands.
Installation
Determine the left and right sides of the machine from
the normal operating position.
Preparing the Machine
Gas Models Only
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the
P ARK position.
4. Shut of f the machine and remove the key .
5. W ait for all moving parts to stop.
Electric Models Only
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the
NEUTRAL position.
4. Engage the parking brake.
5. Shut of f the machine and remove the key .
6. W ait for all moving parts to stop.
© 2023—The T oro® Company
81 1 1 L yndale A venue South
Bloomington, MN 55420
Register at www .T oro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3465-943*
To Next Page
Need help?
General
