Toro TimeCutter HD MyRide 54in - Adjusting the Height of Cut

AdjustingtheHeightofCut
Themachineisequippedwithafootpedaldeck-lift
system.Youcanusethefootpedaltoliftthedeck
brieytoavoidobstaclesorlockthedeckinthe
highestheightofcutortransportposition.Youcan
usetheheight-of-cutleverwiththefootpedaltolock
thedeckinaspeciccuttingheight.
UsingtheFootPedalDeck-Lift
System
•Pressthedeck-liftpedaldowntoraisethedeck;
continuetopressthepedaluntilthedecklocksin
thetransportposition(Figure28).
•Pushonthedeck-liftpedalwithyourfootandpull
thetransportlockhandlerearwardtodisengage
thetransportlock(Figure28).
g024409
g024409
Figure28
TransportLockPosition
AdjustingtheHeightofCut
Youcanadjusttheheightofcutfrom38to114mm
(1-1/2to4-1/2inches)in6mm(1/4inch)increments
byrelocatingtheheight-of-cutpinintodifferenthole
locations.
1.Pushonthedeck-liftpedalwithyourfootand
raisethemowerdecktothetransport-lock
position(alsothe114mm(4-1/2inches)cutting
heightposition)asshowninFigure29.
2.Toadjust,removethepinfromtheheight-of-cut
bracket(Figure29).
3.Selectaholeintheheight-of-cutsystem
correspondingtothedesiredheightofcutand
insertthepin(Figure29).
4.Pushonthedeck-liftpedalwithyourfootand
pullthehandlerearwardtodisengagethe
transportlock(Figure28).
5.Lowerthedeckslowlyuntilthelevermakes
contactwiththepin.
g188850
Figure29
1.Deck-liftpedal
3.Pin
2.Handle
4.Height-of-cutpositions
26