Toro TimeCutter HD ZX4800 - Adjusting the Anti-Scalp Rollers

AdjustingtheHeightofCut
Youcanadjusttheheightofcutfrom38to114mm(1-1/2
to4-1/2inches)in6mm(1/4inch)incrementsbyrelocating
theheight-of-cutpinintodifferentholelocations.
1.Pushonthedeck-liftpedalwithyourfootandraise
themowerdecktothetransport-lockposition(also
the114mm(4-1/2inches)cuttingheightposition)as
showninFigure27.
2.Toadjust,removethepinfromtheheight-of-cut
bracket(Figure27).
3.Selectaholeintheheight-of-cutsystemcorresponding
tothedesiredheightofcutandinsertthepin(Figure
27).
4.Pushonthedeck-liftpedalwithyourfootandpull
thehandlerearwardtodisengagethetransportlock
(Figure26).
5.Lowerthedeckslowlyuntilthelevermakescontact
withthepin.
g188850
Figure27
1.Deck-liftpedal
3.Pin
2.Handle
4.Height-of-cutpositions
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itisrecommended
toadjusttheheightoftheanti-scalprollers.
1.Disengagetheblade-controlswitch(PTO),movethe
motion-controlleverstotheNEUTRAL-LOCKposition,
andengagetheparkingbrake.
2.Shutofftheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Adjusttheanti-scalprollersasshowninFigure28.
g029955
g029955
Figure28
1.Anti-scalproller4.Flangenut
2.Spacer
5.Bolt
3.Bushing
22