Toro TimeCutter Z380 - Maintenance; Recommended Maintenance Schedule(s)

Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first 5 operating
hours
Before each use or daily
Maintenance Procedure
• Change the engine oil.
• Check the safety interlock system.
• Check the engine oil level.
• Check the cutting blades.
• Clean the mower housing.
• Grease all lubrication points.
• Clean the foam air filter element (more often in dirty or dusty conditions).
Every 25 hours
• Check tire pressure.
• Check the belts for wear/cracks.
Every 50 hours • Change the engine oil.
Every 100 hours
Before storage
Replace the paper air filter element (more often in dirty or dusty
conditions).
Change the oil filter (model 74327 only).
Replace spark plug.
Replace fuel filter.
• Drain the fuel tank.
• Charge the battery and disconnect battery cables.
• Perform all maintenance procedures listed above before storage.
• Paint any chipped surfaces.
Important: Refer to your engine operator's manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do
any maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
21