,, 3
1.
2.
Washout fitting
Coupling
Figure 50
3. Hose
Q000555
2
1
,
5.
,
,
,
Lower the mower to the lowest height-of-cut.
Sit on the seat and start the engine. Engage the
blade control switch and let the mower run for
one to three minutes.
Disengage the blade control switch, stop the
engine, and remove the ignition ke 7 Wait for
all moving parts to stop.
Turn the water off and remove the coupling
from the washout fitting.
Note: If the mower is not clean after one
washing, soak it and let it stand for 30 minutes.
Then repeat the process.
Run the mower again for one to three minutes
to remove excess water.
A broken or missing washout fitting
could expose you and others to thrown
objects or blade contact. Contact with
blade or thrown debris can cause injury
or death.
Replace broken or missing washout
fitting immediately, before using
mower again.
Plug any hole(s) in mower with bolts
and locknuts.
• Never put your hands or feet under
the mower or through openings in
the mower.
36
To Next Page
Loading...
