Toro TimeCutter ZS 3200S - Adjusting the Height of Cut

AdjustingtheHeightofCut
Note:Thetransportpositionisthehighest
height-of-cutpositionorcuttingheightat115mm
(4-1/2inches)asshowninFigure27.
Heightofcutiscontrolledbytheleverlocatedtothe
rightoftheoperatingposition(Figure27).
g027697
Figure27
AdjustingtheAnti-Scalp
Rollers
ForMachineswith107cm
(42-inch)MowerDecks
Wheneveryouchangetheheightofcut,adjustthe
heightoftheanti-scalprollers.
Note:Adjusttheanti-scalprollerssothattherollers
donottouchthegroundinnormal,atmowingareas.
1.Parkthemachineonalevelsurface,disengage
theblade-controlswitchandengagetheparking
brake;refertoParkPosition(page13).
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Adjusttheanti-scalprollersto1ofthefollowing
positions:
•Upperhole—usethispositionwiththemower
deckinthe63mm(2-1/2inch)andbelowthe
height-of-cutpositions(Figure28).
•Lowerhole—usethispositionwiththemower
deckinthe76mm(3inch)andabovethe
height-of-cutpositions(Figure28).
g019929
Figure28
1.Anti-scalproller4.Upperhole—themower
deckinthe63mm(2-1/2
inch)andbelowthe
height-of-cutpositions
2.Lowerhole—themower
deckinthe76mm(3
inch)andabovethe
height-of-cutpositions
5.Bolt
3.Flangenut
27