Toro TimeCutter ZX User Manual

W 2004 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Contact us at www.Toro.com
All Rights Reserved
Printed in the USA
Original Instructions (EN)
TimeCutter
)
ZX Riding Mowers
Form No. 3353-782 Rev A
Setup Instructions
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
Description Qty. Use
Bolt, 1/4 x 3/4 inch
Washer, 1/4 inch
Nut, 1/4 inch
2
2
2
Installing the battery
Seat
Spacer
Knob
Flat washer, 5/16 inch
1
2
2
2
Installing the seat
Left-hand control lever
Right-hand control lever
Bolt, 3/8 x 1 inch
Curved washer, 3/8 inch
1
1
4
4
Installing the motion control levers
Hose coupling 1 Washing the underside of the mower
Key 1
Operator’s Manual
Engine Operator’s Manual
1
1
Read before operating the machine.
Registration card 1 Fill out and return to Toro.
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Warning

Toro TimeCutter ZX Specifications

General

Horsepower	22 hp
Transmission	Hydrostatic
Speed	7 mph
Turning Radius	Zero-Turn
Cutting Height	1.5 - 4.5 in
Deck Material	Steel

Summary

Loose Parts Identification

California Proposition 65 Warning

Warning about lead and lead compounds in battery parts causing cancer and reproductive harm.

Installing the Battery

Battery Safety Precautions

Safety warnings regarding electrolyte handling and charging processes.

Installing Motion Control Levers

Installing the Seat

Mower Maintenance and Checks

Washing Mower Underside

Instructions for washing the underside of the mower using a hose coupling.

Checking Mower Adjustment

Guidance on checking and adjusting mower deck leveling.

Checking Engine Oil Level

Procedure to check engine oil level before operation.

Checking Tire Pressure

Instructions for checking and verifying tire pressure.