Toro TITAN series User Manual

FormNo.3382-315RevA
TITAN
®
RidingMower
ModelNo.Allmodels
SetupInstructions
Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
1
Nopartsrequired
–
Connectthebattery.
Rearhitch1
Bolt(5/16x2-1/2inches)
2
2
Locknut(5/16inch)
2
Installtherearhitch.
3
Nopartsrequired
–
Setupthemotion-controllevers.
4
Nopartsrequired
–
SetuptheRolloverProtectionSystem
(ROPS)bar.
5
Nopartsrequired
–
Checkthemoweradjustment.
Ignitionkey1
Hosecoupling(notincludedwithCE
models)
1
Operator'sManual
1
EngineOperator'sManual
1
6
Operatortrainingmaterial
1
Completethesetup.
Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.
©2013—TheToro®Company
8111LyndaleAvenueSouth
Bloomington,MN55420
Registeratwww.Toro.com.
OriginalInstructions(EN)
PrintedintheUSA.
AllRightsReserved
*3382-315*A

Toro TITAN series Specifications

General

Transmission	Hydrostatic
Deck Material	Fabricated Steel
Cutting Width	60 inches
Engine Displacement	747cc
Warranty	3-Year / 300-Hour (Limited Residential); 30-Day Commercial

Summary

Riding Mower Setup Instructions

Connecting the Battery

Procedure for correctly connecting the mower's battery, including securing the negative cable.

Installing the Rear Hitch

Instructions for attaching the rear hitch assembly to the mower frame using bolts and locknuts.

Setting up Motion-Control Levers

Steps to properly align, adjust, and secure the motion-control levers to the control-arm shaft.

Setting up Rollover Protection System (ROPS) Bar

Procedure for installing the ROPS bar by relocating bolts and nuts to specific holes on the ROPS plate.

Checking Mower Adjustment

Guide to adjusting the side-to-side level and front-to-rear blade slope for optimal performance.

Completing the Setup

Final steps including checking tire pressure, oil level, side-discharge chute, and gathering manuals.