Toro Titan Z4800 - Page 118

ENGINE
6-72007 - 2008 Titan Z Service Manual
6
7. Install the blue wire to the oil sending sensor located
QH[WWRWKHRLO¿OWHU)LJ
4. Position the 2 ground wires onto the engine ground
base. Install a nut to secure the 2 ground wires (Fig.
329).
6. Plug the yellow/white wire plug to the grey/black
(fuel solenoid and the engine magneto) wire plug
(Fig. 331).
Fig. 329 IMG-0395a
5. Position the heavy red wire onto the starter terminal.
Install a nut to secure the heavy red wire to the
starter terminal (Fig. 330).
Fig. 330 IMG-0394a
Fig. 331 IMG-0258
Fig. 332 IMG-0264a