Toro Titan Z4800 - Change the Hydraulic System Filter; Servicing the Spark Plug

CHASSIS
3-192007 - 2008 Titan Z Service Manual
3
8. Position the control panel onto the right hand fender.
Install four screws to secure the control panel to the
right hand fender (Fig. 067).
7. Plug the wire harness plug onto the ignition switch
(Fig. 066).
9. Install a bolt, washer, and nut securing the right hand
rear console bracket and right hand fender (Fig.
068).
Fig. 066 IMG-0219
Fig. 067 IMG-0208
Fig. 068 IMG-0206
 ,QVWDOODEROWDQGÀDQJHQXWWRVHFXUHWKHULJKWKDQG
engine guard to the rear engine guard. Install a
screw to secure the right hand engine guard to the
right hand fender (Fig. 069).
Fig. 069 IMG-0205
A. Bolt and nut B. Screw
A
B