Page 4
Servicing the Engine
Engine is shipped with oil; check oil level and if
necessary fill to the appropriate level with oil as
specified in Engine Owner’s Manual.
Servicing the Hydraulic Oil
The machine is shipped with hydraulic oil. Verify level
on Expansion Tank. (See Figure 5)
1. Start engine and drive the machine forward and
backward for a few minutes to allow any extra air
to purge out of the hydraulic system.
2. Stop engine and wait for all moving parts to stop.
Remove key and engage parking brake.
3. Check expansion tank and if necessary add
MOBIL 1 15W-50 synthetic motor oil to the FULL
COLD line.
NOTE: The proper amount of oil should have
been added at the factory. If the reservoir is
slightly over full, do not remove fluid. The level
will go down once all of the air is purged from the
system.
Figure 5
1. Seat 3. Expansion Tank
2. Engine
4. Replace expansion tank cap and tighten until
snug. Do not overtighten.
Installing the Discharge Deflector
1. Install discharge deflector (Figure 6).
2. Place the spring on the rod. Slide rod, straight
end, through the front discharge deflector
bracket, discharge deflector, and rear deflector
bracket.
3. Make sure that the spring and rod are installed
so that the rod is retained from sliding out by the
front bracket and the spring holds the discharge
deflector in the down position. Refer to
(Figure 6) for proper orientation.
Important: The discharge deflector must be
spring loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
Figure 6
1. Mower deck 4. Spring
2. Discharge deflector 5. Rod
3. Discharge deflector bracket 6. Assembled view
© 2007 The Toro Company Contact us at www.Toro.com.
8111 Lyndale Ave. South All Rights Reserved
Bloomington, MN 55420 Printed in the USA.
To Previous Page
Loading...
