Toro Titan ZXM4875 - User Manual

Toro Titan ZXM4875

88 pages

To Next Page

To Next Page

Loading...

Operator’s Manual

Titan ZX4875, ZXM4875, ZXM5475, or

ZXM6075 Riding Mower

Model—Serial Range

76420—400000000 and Up

76425—400000000 and Up

76530—400000000 and Up

76635—400000000 and Up

3464-637A

Original Instructions (EN)

*3464-637*A

Table of Contents

Questions and Answers:

A
April GoldenAug 20, 2025
What to do if my Toro Titan ZXM4875 engine does not start?
- A
  Ann WilliamsAug 20, 2025
  If your Toro Lawn Mower engine doesn't start, starts hard, or fails to keep running, first check if the fuel tank is empty and fill it if needed. Ensure the choke is on. Clean or replace the air-cleaner element if it's dirty. Make sure the spark-plug wire(s) is securely connected. Install a new, correctly gapped spark plug if the current one is pitted, fouled, or has an incorrect gap. Replace the fuel filter if it's dirty. Also, ensure the oil level in the crankcase is adequate by adding oil if necessary. If you have dirt, water, or stale fuel in the fuel system, or are using incorrect fuel, contact an Authorized Service Dealer.
A
Alicia KellyAug 22, 2025
Why my Toro Titan ZXM4875 engine does not start?
- S
  Stephen RiveraAug 22, 2025
  If your Toro Lawn Mower engine does not start, starts hard, or fails to keep running, several factors could be at play. First, ensure the fuel tank isn't empty by filling it. If your model has a choke, make sure it's turned on. A dirty air cleaner can also cause issues, so clean or replace it. Check that the spark-plug wire(s) is securely connected and that the spark plug(s) isn't damaged or improperly gapped; replace if necessary. Other potential causes include a dirty fuel filter (replace it), dirt, water, or stale fuel in the fuel system (in this case you should contact an Authorized Service Dealer), incorrect fuel in the tank (drain and replace with the proper type), or low oil level in the crankcase (add oil).
N
Nancy ReevesAug 23, 2025
What to do if my Toro Titan ZXM4875 Lawn Mower starter does not crank?
- J
  James FloresAug 25, 2025
  If the starter on your Toro Lawn Mower doesn't crank, first ensure the blade-control switch is disengaged. Next, check that the motion-control levers are in the PARK position. If these aren't the problem, charge the battery, and check the electrical connections for corrosion or looseness. Replace the fuse if it's blown. If the problem persists, a relay or switch may be damaged, and you should contact an Authorized Service Dealer.
B
Brenda LopezAug 26, 2025
Why does my Toro Titan ZXM4875 engine lose power?
- B
  Brenda CastanedaAug 26, 2025
  Your Toro Lawn Mower engine may lose power if the engine load is excessive; reduce the ground speed. Check if the air cleaner is dirty and clean it. Ensure the oil level in the crankcase is sufficient by adding oil if needed. Also, inspect the cooling fins and air passages under the engine blower housing for obstructions and remove them. Replace the spark plug(s) if they are pitted, fouled, or have an incorrect gap. If there is dirt in the fuel filter, replace it. For other potential issues such as a blocked fuel-tank vent, dirt, water, or stale fuel in the fuel system, or incorrect fuel in the fuel tank, contact an Authorized Service Dealer.
E
Emily JohnsonAug 27, 2025
How to fix uneven cutting height on my Toro Lawn Mower?
- J
  Julie AndersonAug 28, 2025
  To fix an uneven cutting height on your Toro Lawn Mower, start by sharpening the blade(s). If a cutting blade(s) is/are bent, install new ones. Ensure the mower is level from side-to-side and front-to-rear. If applicable, adjust the anti-scalp wheel height. Clean the underside of the mower deck and adjust the tire pressure. If a blade spindle is bent, contact an Authorized Service Dealer.
J
James AllenAug 29, 2025
Why are the blades not rotating on my Toro Titan ZXM4875?
- B
  Brian SanchezAug 30, 2025
  If the blades on your Toro Lawn Mower are not rotating, it could be due to a worn, loose, or broken drive belt, so install a new one. If the drive belt is off of the pulley, install the drive belt and check the adjusting shafts and belt guides for the correct position. For a faulty power-takeoff (PTO) switch or PTO clutch, or a worn, loose, or broken mower belt, contact an Authorized Service Dealer.
A
Anthony BowmanAug 31, 2025
Why is my Toro Titan ZXM4875 Lawn Mower engine overheating?
- D
  Dillon TannerAug 31, 2025
  If your Toro Lawn Mower engine overheats, there are several potential causes. First, the engine load might be excessive, so try reducing the ground speed. Check the oil level in the crankcase and add oil if it's low. Make sure the cooling fins and air passages under the engine-blower housing are clear of obstructions. Also, a dirty air cleaner can contribute to overheating, so clean or replace the air-cleaner element. If dirt, water, or stale fuel is in the fuel system, contact an Authorized Service Dealer.
A
Alison OsborneSep 3, 2025
What to do if the blades do not rotate on my Toro Titan ZXM4875?
- L
  Laura ArcherSep 3, 2025
  If the blades on your Toro Lawn Mower do not rotate, several issues could be the cause. Check if the drive belt is worn, loose, or broken, and install a new one if needed. If the drive belt is off of the pulley, reinstall it and check the adjusting shafts and belt guides for the correct position. If the power-takeoff (PTO) switch or PTO clutch is faulty, or if the mower belt is worn, loose, or broken, contact an Authorized Service Dealer to resolve these issues.
M
Michael JohnsonSep 4, 2025
Why does my Toro Lawn Mower engine overheat?
- L
  Laura McbrideSep 5, 2025
  Your Toro Lawn Mower engine may overheat due to several reasons. The engine load might be excessive, so reduce the ground speed. The oil level in the crankcase could be low, so add oil. The cooling fins and air passages under the engine-blower housing might be plugged, so remove the obstruction. The air cleaner could be dirty, so clean or replace the air-cleaner element. If the issue persists, it could be due to dirt, water, or stale fuel in the fuel system, in which case you should contact an Authorized Service Dealer.
K
Kathryn BlackSep 6, 2025
Why does my Toro Titan ZXM4875 vibrate abnormally?
- Q
  qhickmanSep 6, 2025
  Abnormal vibrations in your Toro Lawn Mower can be caused by several factors. The cutting blade(s) might be bent or unbalanced, in which case you should install new ones. Check if the blade mounting bolt and the engine mounting bolts are loose and tighten them. Also, inspect the engine pulley, idler pulley, or blade pulley for looseness and tighten them as needed. For issues like a damaged engine pulley, a bent blade spindle, or a loose/worn motor mount, it is best to contact an Authorized Service Dealer.

Toro Titan ZXM4875 Specifications

General

Drive System	Hydrostatic
Cutting Width	48 inches
Seat	High-back with armrests
Ground Speed Reverse	4 mph (6.4 km/h)
Warranty	3 years

Related product manuals

Preview: Toro titan zx

Toro TITAN ZX6000

Preview: Toro Titan ZX4800

Toro Titan ZX4800

Toro TITAN ZX4820

Preview: Toro TITAN ZX6020

Toro TITAN ZX6020

Preview: Toro TITAN ZX5000

Toro TITAN ZX5000

Preview: Toro Titan ZX4875

Toro Titan ZX4875

Preview: Toro TITAN ZX 5400

Toro TITAN ZX 5400

Preview: Toro TITAN ZX 4800

Toro TITAN ZX 4800

Preview: Toro 74920 TITAN ZX4820

Toro 74920 TITAN ZX4820

Toro 74924 TITAN ZX5420

Preview: Toro Titan Z4800

Toro Titan Z4800