To Next PageTo Next Page
Need help?Do you have a question about the Toro WHEEL HORSE Series and is the answer not in the manual?
General| Category | Lawn Mower |
|---|---|
| Brand | Toro |
| Series | WHEEL HORSE |
| Horsepower | Varies by model |
| Cutting Width | Varies by model |
| Fuel Capacity | Varies by model |
| Weight | Varies by model |
| Turning Radius | Varies by model |
| Speed | Varies by model |
| Transmission | Varies by model |
Install front wheels onto the tractor axle, ensuring correct washer and cotter pin placement.
Verify and set front and rear tire pressure to 12 psi (83 kPa) for optimal performance.
Mount the steering wheel onto the steering shaft and secure it using the provided spirol pin.
Position the tractor seat and secure it to the seat base using shoulder bolts and knob.
Prepare the battery by filling it with electrolyte and charging it before installation.
Add engine oil to the crankcase, checking the level carefully against the dipstick.
Remove shipping pin and ensure the mower discharge chute is in the correct down position.
Adjust mower side-to-side level and front-to-rear blade slope as per manual instructions.
Refer to the Operator's Manual for proper greasing and lubrication procedures.
Insert the key into the ignition switch and verify the safety system is functioning.
Remove trapped air from the hydro transaxle by operating the drive control in specific positions.
Adjust the traction control pedal linkage to prevent creep when the pedal is not engaged.
Verify the traction control pedal does not contact the footrest before reaching its stop.
Adjust the shift cable for smooth gear engagement if the lever movement is firm or difficult.
Perform a test drive to ensure all electrical and mechanical systems operate correctly.
Confirm mower side-to-side level and front-to-rear blade slope are correctly adjusted.
