Toro Wheel Horse 78350

Questions and Answers

K
Kelly HallAug 1, 2025
What to do if blade(s) does not rotate on Toro Lawn Mower?
- F
  fsheppardAug 1, 2025
  If the blade(s) on your Toro Lawn Mower does not rotate, it could be due to a worn, loose, or broken blade drive belt, in which case you should install a new blade drive belt. Another possibility is that the blade drive belt is off the pulley; reinstall the blade drive belt and check the idler pulley and belt guides for correct positioning. A worn, loose, or broken PTO belt could also be the cause; install a new PTO belt.
A
anthonydavisAug 6, 2025
What to do if the blades on my Toro Lawn Mower won't rotate?
- L
  Lauren RomanAug 6, 2025
  If the blades on your Toro Lawn Mower are not rotating, the issue could be related to the blade drive belt or the PTO belt. A worn, loose, or broken blade drive belt requires a replacement. Similarly, if the PTO belt is worn, loose, or broken, install a new PTO belt. Also, ensure the blade drive belt is properly installed on the pulley, and inspect the idler pulley and belt guides for correct positioning.
T
Tina LindseyAug 11, 2025
How to fix uneven cutting height on my Toro Lawn Mower?
- P
  Paul YangAug 11, 2025
  Uneven cutting height on your Toro Lawn Mower can be attributed to a few factors. First, check and set the tire pressure to the correct levels. Second, ensure that the mower deck is level from side to side and front to rear. Lastly, a dirty mower deck underside can also cause an uneven cut; clean the underside of the mower thoroughly.
H
hfosterAug 15, 2025
How to fix uneven cutting height on Toro Wheel Horse 78350?
- H
  hestersharonAug 16, 2025
  Uneven cutting height on your Toro Lawn Mower can be caused by several factors. First, check that the tire pressure is correct and set it accordingly. If that's not the issue, ensure the mower is level from side-to-side and front-to-rear. Lastly, a dirty mower underside can also lead to uneven cutting; clean the underside of the mower.
M
Mark SosaAug 21, 2025
Why is my Toro Wheel Horse 78350 vibrating so much?
- H
  henrymasonAug 21, 2025
  Excessive vibration in your Toro Lawn Mower can stem from several sources. It may be due to a bent or unbalanced cutting blade, in which case you should install new cutting blade(s). Another cause could be a loose blade mounting bolt, which requires tightening. Similarly, check for loose engine mounting bolts and tighten them as necessary. A loose engine pulley, idler pulley, or blade pulley could also be the culprit; ensure these are properly tightened. If the engine pulley is damaged, it's best to contact an Authorized Service Dealer.
G
gallaghergeorgeAug 27, 2025
Why is my Toro Wheel Horse 78350 vibrating abnormally?
- P
  psparksAug 27, 2025
  If your Toro Lawn Mower is vibrating abnormally, several issues could be the cause. It might be due to a bent or unbalanced cutting blade, in which case you should install new cutting blade(s). Alternatively, the blade mounting bolt or engine mounting bolts could be loose; ensure you tighten these. A loose engine pulley, idler pulley, or blade pulley could also be the culprit, so tighten the appropriate pulley. If the engine pulley is damaged, it is recommended to contact an Authorized Service Dealer.