16
Install Rear Fenders
1. Loosen the locknuts and capscrews securing tail light
brackets to right and left frame brackets (Fig. 1).
2. Pivot tail light brackets rearward and tighten capscrews
and locknuts.
1
Figure 1
1. Tail light bracket
3. Secure rear of each tail light bracket to rear of frame
brackets with a 5/16–18 x 1” lg. capscrew, .344” I.D.
flatwasher and locknut, as shown in figure 1.
1
2
Figure 2
1. Fender 2. Support plate
4. Loosely secure a fender to each side of frame with a
support plate, (5) 3/8–16 x 1.25” lg. capscrews, .406”
I.D. washers and (4) locknuts as shown in figure 2.
A weld nut is in place to secure each rear capscrew.
5. Tighten all fasteners.
Install Wheels
1. Remove lug nuts securing wheels to wheel brackets.
Retain lug nuts.
2. Mount wheels and install lug nuts. Torque lug nuts to
55–75 ft-lb.
1
2
Figure 3
1. Wheel 2. Wheel nut
Install Steering Wheel
1. Remove jam nut from steering shaft. Slide foam seal,
steering wheel and washer onto steering shaft.
2. Secure steering wheel to shaft with jam nut and tighten
it to 10–15 ft-lb.
3. Install cap to steering wheel.
1
2
3
4
5
Figure 4
1. Steering wheel
2. Jam nut
3. Cap
4. Washer
5. Foam seal
To Next Page
Loading...
