EasyManua.ls Logo

Toro Workman 3300–D - Recommended Maintenance Schedule

Toro Workman 3300–D
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After first 10 hours
Check cable adjustments
Torque wheel lug nuts
Check alternator and fan belts
Replace transaxle filter
After first 50 hours
Replace the engine oil and filter.
Torque cylinder head and adjust valves
Every 50 hours
Check the battery fluid level.
Check the battery cable connections.
Service the air cleaner.
Every 100 hours
Lubricate all grease fittings
Inspect condition and wear of tires
Check front differential oil level (4WD)
Replace engine oil and filter
Inspect cooling system hoses
Every 200 hours
Check cable adjustments
Check alternator and fan belts
Service air cleaner filter
Check front axle CV boot joint (4WD)
Check engine RPM (idle and full throttle)
Torque wheel lug nuts
Every 400 hours
Check front wheel alignment
Inspect service and parking brakes
Inspect fuel lines
Replace electric fuel pump filter
Replace fuel/water separator filter
Adjust valves
Every 800 hours
Replace transaxle filter
Change transaxle oil
Clean transaxle strainer
Pack front wheel bearings
Change front differential oil (4WD)
Every 1200 hours or 2
years (whichever
occurs first)
Replace all interlock switches
Coolant System – flush/replace fluid
Fuel tank – Drain/flush
Change brake fluid
1
immediately after every washing, regardless of the interval listed
Important Refer to your engine operators manual for additional maintenance procedures.

Table of Contents

Related product manuals