Toro Workman HDX - Page 3

Installation
Media and Additional Parts
Description
Qty .
Use
Compression spring tool
1 Installing the compression spring.
CVT -intake hood assembly (W orkman
HDX-Auto machines only)
1
Installing the CVT -intake hood assembly .
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Raise or remove the bed from the machine (if
equipped).
Note: Refer to the machine Operator ’ s Manual
for more detailed information on raising and
removing the bed.
4. Shut of f the engine, remove the key , and allow
the machine to cool.
5. Disconnect the battery; refer to the Operator ’ s
Manual .
6. While grasping the hood in the headlight
openings, lift up on the hood to release the lower
mounting tabs from the slots in the bumper
( Figure 1 ).
g010314
Figure 1
1. Hood
7. Pivot the bottom of the hood upward until you
can pull the top mounting tabs from the frame
slots ( Figure 1 ).
8. Pivot the top of the hood forward and unplug the
wire connectors from the headlights ( Figure 1 ).
9. Remove the hood.
3