Toro Workman HDX - Page 4

2
Removing the Center
Console Panel and Seats
No Parts Required
Removing the Center Console
Panel
For W orkman HDX Machines
1. Unscrew and remove all the knobs from the
console levers and from the gear-shift lever
( Figure 2 ).
g023161
Figure 2
1. Shifter rod 4. Control rod
2. Jam nut
5. Control knob
3. Shifter handle
2. Remove the jam nut from the gear-shift lever
( Figure 2 ).
3. Remove the 6 screws securing the outside edge
of the cover plate of the center console to the
chassis and remove the cover plate ( Figure 3 ).
g023165
Figure 3
1. Screw 2. Cover plate
Removing the Center Console
Panel
For W orkman HDX-Auto Machines
1. Remove all the knobs from the console levers
and from the transmission lever by rotating the
knobs counterclockwise ( Figure 4 ).
g024571
Figure 4
1. Brake lever
5. T ransmission lever (L
position) knob
2. Hydraulic-lift lever knob 6. Hydraulic-lift lock (locked
position—left)
3. Speed-range lever knob 7. Speed-range lever (A
position)
4. T ransmission lever knob
4