Toro Workman HDX - Page 5

2. Remove the 4 hex-head screws securing the
shift-indicator cover to the seat shroud ( Figure
5 ).
g024588
Figure 5
1. Indicator connector
4. Control cover
2. Shift-indicator cover
5. Machine harness
connector
3. Hex-head screws
3. Lift the shift indicator up, disconnect the
indicator connector from the machine harness
connector , and remove the indicator cover from
the machine ( Figure 5 ).
4. Remove the 6 hex-head screws securing the
control cover to the seat shroud, and remove the
control cover ( Figure 5 ).
Removing the Seats
Remove the 8 socket-head bolts securing the seat
rails of the seat to the chassis, and remove the seats
( Figure 6 ).
g023164
Figure 6
1. Socket-head bolts 3. Seat
2. Seat rail
3
Removing the CVT Cooling
Duct (HDX-Auto Machines
only), Coolant T ank, ROPS
Assembly , and Seat Shroud
No Parts Required
Removing the CVT Cooling Duct
For HDX-Auto Machines Only
Remove the hose clamp securing the CVT -cooling
duct to the ange of the CVT intake at the back of the
ROPS panel on the passenger side ( Figure 7 ).
g024791
Figure 7
1. CVT -intake hose
3. Intake-tube connector
2. Hose clamp
5