Removing the Coolant T ank
1. Lift the coolant tank up and out of the support
pocket on the back of the seat shroud ( Figure 8 ).
g023166
Figure 8
1. Coolant tank 3. Seat shroud
2. Coolant-tank bracket
2. Set the coolant tank upright onto the
engine/chassis.
Removing the ROPS Assembly
1. Remove the 6 bolts securing the ROPS
assembly to the frame of the machine as shown
in Figure 9 and Figure 10 .
Note: Do not discard the bolts.
g026469
Figure 9
2. Remove the Operator ’ s Manual tube and
R-clamps from the ROPS assembly and set it
aside.
g026470
Figure 10
Removing the Seat Shroud
For W orkman HDX machines:
1. Engage the parking brake ( Figure 1 1 ).
g023171
Figure 1 1
1. Gear-selector boot 4. Dif ferential-lock rod
2. Gear-selector rod 5. Hydraulic-bed lift rod
3. Parking brake
6. High-low range shifter rod
2. Move the dif ferential-lock rod forward and to the
right to lock it in the engaged position ( Figure
1 1 ).
6
To Next Page
Loading...
