Toro Workman HDX - Page 8

The jacking point at the front of the machine is under
the front, center frame support ( Figure 15 ).
g009823
Figure 15
1. Front jacking points
Removing the Front Wheels
1. Remove the 5 lug nuts securing the front wheel
to the wheel hub ( Figure 16 ).
g024558
Figure 16
1. Lug nuts 3. Wheel hub
2. Front wheel
2. Remove the wheel from the wheel hub ( Figure
16 ).
3. Repeat steps 1 and 2 for the front wheel on the
other side of the machine.
5
Installing the Compression
Spring
Parts needed for this procedure:
2
Compression spring (black)
Procedure
1. Using a compression spring tool as specied in
Figure 17 , install the compression spring rod
through the holes in each spring cradle ( Figure
18 ).
Important: Use caution when removing
the spring cradle; the spring is under
compression.
g026281
Figure 17
1. 51 cm (20 inches) 2. 13 cm (5 inches)
g026472
Figure 18
1. Spring cradle 3. Stabilizer link
2. Control arm
8