2. Measure and note the length of the springs.
3. Install the nuts and washers on both ends of the
rod ( Figure 19 ).
g026495
Figure 19
4. T ighten 1 nut on each rod to secure the springs
( Figure 19 ).
5. Remove the bolts and nuts from the end of each
stabilizer link (A of Figure 20 ).
6. Remove the bolts and nuts from the control arm
securing each spring cradle (B of Figure 20 ).
7. Remove the spring cradles and springs from the
machine (C of Figure 20 ).
Note: Note the position of the decals on the
spring cradles. The cradles need to be put back
in the same location.
g026276
Figure 20
8. Remove the current springs from the spring
cradles and place the springs from this kit (black
springs) in the spring cradles.
9. Use the compression spring tool rod to compress
the springs to the measurement taken in step 2 .
10. Place the springs and cradle back into the
machine.
1 1. Install the previously removed bolts and nuts
from the stabilizer links and control arm.
12. Install the front wheels and lower the machine.
13. T orque the lug nuts to 109 to 122 N∙m (80 to 90
ft-lb).
9
To Next Page
Loading...
