Toro Workman HDX - Page 10

6
Installing the Inner Fender
Parts needed for this procedure:
1
Inner fender
2 Fender strap
6
Hex-head ange bolt (1/4 x 3/4 inch)
8
Flange nut (1/4 inch)
2 Rubber bumper
2 W asher
2
Cable tie
Procedure
W ARNING
Using a drill without proper eye protection
may allow debris to enter the eye, causing
injury .
When drilling, always wear eye protection.
1. Align the fender straps at the bottom edge of the
seat base frame, and use the fender straps as a
template to mark and drill 3 holes (5/16 inch) on
each side of the seat base frame ( Figure 21 ).
g245709
Figure 21
1. Fender strap
2. Edge of the seat base
frame
2. Install the inner fender and fenders straps using
6 hex-head ange bolts (1/4 x 3/4 inch) and 6
ange nuts (1/4 inch) as shown in Figure 22 .
g245710
Figure 22
1. Inner fender
3. Fender strap
2. Flange nut (1/4 inch) 4. Hex-head ange bolt (1/4
x 3/4 inch)
3. Fold down the ap and tuck the ap behind the
oor ange ( Figure 23 ).
4. Secure the ap with 2 cable ties around the
center frame tube ( Figure 23 ).
g245761
Figure 23
1. Cable tie
2. Flap tucked behind the
oor ange
10