Toro Workman HDX - Page 11

5. Install a rubber bumper using a washer and
ange nut (1/4 inch) on each side ( Figure 24 ).
g245762
Figure 24
1. Rubber bumper
3. Flange nut (1/4 inch)
2. W asher
7
Installing the Cab Mount
Brackets
Parts needed for this procedure:
1
Left mount assembly
1 Right mount assembly
2
Adjuster bolt (3/8 x 2 inches)
2
Hex nut (3/8 inch)
4
Hex-ange head bolt (3/8 x 1 inch)
4
Flange nut (3/8 inch)
2 Front cab mount bracket
2
Hex-head bolt (7/16 inch)
2 Thrust washer
2
Locknut (1/2 inch)
2 Rubber isolator
2
Spacer
2 W asher
2 Locknut
2
Flange-head bolt (1/2 x 2-1/4 inches)
Procedure
1. Install the rear brackets on the machine ( Figure
25 ) using the hardware removed from the ROPS
in Removing the ROPS Assembly ( page 6 ) .
g026243
Figure 25
2. T orque the bolts to 94 to 108 N∙m (70 to 80 ft-lb).
3. Install the left mount assembly and right mount
assembly to the front cab mount brackets using
2 hex-ange head bolts (3/8 x 1 inch) and 2
ange nuts (3/8 inch) on each side ( Figure 26 ).
Use the center holes in the mount assembly
when installing.
4. Install the adjuster bolt (3/8 x 2 inches) and
hex nut (3/8 inch) into the left mount assembly
and right mount assembly on each side of the
machine ( Figure 26 ).
g245967
Figure 26
1. Flange nuts (3/8 inch) 5. Hex-ange head bolts (3/8
x 1 inch)
2. Front cab mount bracket
6. Adjuster bolt (3/8 x 2
inches)
3. Center holes 7. Hex nut (3/8 inch)
4. Left mount assembly
5. Install the front cab mount brackets using a
hex-head bolt (7/16 inch), thrust washer , and
locknut (1/2 inch) on each side ( Figure 27 ).
1 1