Toro Workman HDX - Page 12

g245966
Figure 27
1. Hex-head bolt (7/16 inch) 3. Locknut (1/2 inch)
2. Thrust washer 4. Front cab mount bracket
6. Install the 2 rubber isolators using a ange-head
bolt (1/2 x 2-1/4 inches), spacer , washer , and
locknut on each side ( Figure 28 ).
Note: Use soapy water to assist with installing
the bracket-support mounts.
g245968
Figure 28
1. Flange-head bolt (1/2 x
2-1/4 inches)
4. W asher
2. Rubber isolator 5. Locknut
3. Spacer
8
Installing the Seat Shroud
No Parts Required
Procedure
Both machines:
1. Align the opening in the seat shroud for the
parking brake with the parking-brake handle.
2. Align the hole in the gear-selector boot with the
rod for the gear selector .
3. Align the opening in the seat shroud for the rods
for the lift bed control, high-low range shifter ,
and the dif ferential lock.
4. Lower the seat shroud down.
5. Align the holes in the shroud for the seat
mounting with the seat-support brackets of the
chassis.
Do not tighten the bolts.
6. Plug in the shift indicator and secure the controls
bracket with the screws ( Figure 12 and Figure
14 ) removed in Removing the Seat Shroud
( page 6 ) .
Important: This step applies to W orkman
HDX-Auto machines only .
12