Toro Workman HDX - Page 13

9
Installing the Side-Plate
Panels and Cab Frame
Parts needed for this procedure:
2
Side-plate panel
1
Cab frame
4
Bolt (1/2 inch)
4
W asher (1/2 inch)
4
Nut (1/2 inch)
1 Lower dash seal
Procedure
1. Loosen the bolts on the fenders approximately
1 turn to allow room for the side-plate panels to
slide into place.
2. Slide the side-plate panels between the seat
shroud and side fenders ( Figure 29 ).
Note: Ensure that the panels are seated fully
before tightening the bolts.
g026246
Figure 29
3. T ighten the bolts on the fenders.
Note: Do not overtighten the bolts.
4. Install the lower dash seal to the cab ( Figure 30 ).
Ensure that you install the seal with longer lip
to the front ( Figure 30 ).
g246051
Figure 30
1. Lower dash seal
2. Longer lip to the front
5. Hold the cab frame using the lifting points and
place it on the machine ( Figure 31 ).
Note: Before lowering the cab on to the
machine, apply soapy water to the dash to keep
the lower dash seal lubricated.
Note: Ensure that the front and rear lips on the
lower dash seal do roll under during installation.
13