XL GEAR DRIVE
2 - 8 XL Lawn Tractor Service Manual
7. Route belt back over the pedal pivot rod, the idler
pivot bracket, and around the transaxle pulley
(Figure 30).
Figure 30
mvc-826
8. Install the idler pulley to the idler bracket. Note
the correct hole location of the bolt and nut
retaining the pulley and belt guide bracket (Figure
31).
Figure 31
mvc-828
9. Hook the idler spring to the idler bracket (Figure
32).
Figure 32
mvc-829
10. Install the right side belt guide and adjust to within
1/8” (3mm) of the transaxle pulley and belt. Adjust
and tighten the left belt guide so it is within 1/8”
(3mm) of the transaxle pulley and belt (Figure 21
and Figure 33).
Figure 33
mvc-796
1/8” (3mm)
To Next Page
Loading...
