Toro Z Master G3 - Installing the Motion Control Levers

8
InstallingtheMotionControl
Levers
Partsneededforthisprocedure:
1Rightcontrollever
1
Leftcontrollever
4
Bolt(3/8x1inch)(2areassembled)
4
Nut(3/8inch)(2areassembled)
Procedure
1.Rotatethemotioncontrolleverstotheupright
position.
2.Looselyinstallthecontrolleversontheoutsideof
theposts,using4boltsand4nuts.
Note:Installthecontrolleversinthetopand
middleholesforthehighpositionorthemiddleand
bottomholesforthelowposition,asdesired.
Figure12
1.Bolt(3/8x1inch)3.Controllever
2.Handle
4.Nut(3/8inch)
3.Raisetheleversandalignthemtogetherinthe
neutralpositionandtightenthebolts.
Figure13
Note:Ifthemachineisnotproperlytracking,refer
toAdjustingtheTrackinginyourOperator’sManual.
9
InstallingtheLiftAssistPedal
Partsneededforthisprocedure:
1
Carriagebolt(3/8x1-1/2inches)
1
Flangelocknut(3/8inch)
Procedure
1.Ifneeded,loosentheexistingboltandnutforthe
liftassistpedal.
2.Rotatetheliftassistpedaltothecorrectposition
andinstallthecarriagebolt(3/8x1-1/2inches)and
locknut(3/8inch)(Figure14).Tightenbothbolts.
6