Figure 22
1. Cam lock
3. Rotate cam to increase or
decrease locking pressure
2. Lever
4. Slot
Positioning the Flow Bafe
T he follo wing figures are only recommendations
for use . Adjustments will v ar y b y g rass type ,
moisture content, and height of g rass .
Note: If the engine po w er dra ws do wn and the
mo w er g round speed is the same , open up the
baffle .
Position A
T his is the full rear position. T he sug g ested use
for this position is a follo ws .
• Use for shor t, light g rass mo wing conditions .
• Use in dr y conditions .
• F or smaller g rass clippings .
• Propels g rass clippings far ther a w a y from the
mo w er .
Figure 23
Position B
Use this position when bag ging .
Figure 24
Position C
T his is the full open position. T he sug g ested use
for this position is as follo ws .
• Use in tall, dense g rass mo wing conditions .
• Use in w et conditions .
• Lo w ers the engine po w er consumption.
• Allo ws increased g round speed in hea vy
conditions .
• T his position is similar to the benefits of the
T oro SFS mo w er .
23
To Next Page
Loading...
