Toro Z587L Z Master - Page 59

Problem
Possible Cause Corrective Action
1. More coolant is needed. 1. Check and add coolant.
2. Air intake screens are
dirty.
2. Clean with every use.
3. Restricted airow into
the engine.
3. Inspect and clean the
radiator screen with
every use.
4. Radiator ns are dirty. 4. Clean the radiator ns.
5. The engine oil level is
incorrect.
5. Fill or drain to the full
mark.
6. Fuel mixture is lean. 6. Contact your Authorized
Service Dealer.
Engine overheats.
7. Engine load is excessive. 7. Reduce the ground
speed.
1. Tension spring not
connected.
1. Connect the tension
spring.
2. By pass valve is not
closed tight.
2. Tighten the by pass
valve.
3. Traction belt is worn,
loose or broken.
3. Contact an Authorized
Service Dealer.
4. Traction belt is off a
pulley.
4. Contact an Authorized
Service Dealer.
Machine does not drive.
5. Hydraulic uid level is
low or too hot.
5. Add hydraulic uid to
reservoir or let it cool
down.
1. Cutting blade(s) is/are
bent or unbalanced.
1. Install new cutting
blade(s).
2. Blade mounting bolt is
loose.
2. Tighten the blade
mounting bolt.
3. Engine mounting bolts
are loose.
3. Tighten the engine
mounting bolts.
4. Loose engine pulley,
idler pulley, or blade
pulley.
4. Tighten the appropriate
pulley.
5. Engine pulley is
damaged.
5. Contact an Authorized
Service Dealer.
Abnormal vibration.
6. Blade spindle is bent. 6. Contact an Authorized
Service Dealer.
59