Fig. 41: Emergency Stop Switch
1
Lanyard
2
Emergency Stop Switch
1. Lay the pilot-line (1) via the Emergency Stop Switch (2).
2. Place the Emergency Stop Switch (2) in the RUN position.
You can now start the system using the key switch.
Position of the key switch for the throttle lever with side mounting, top
mounting, and double throttle lever with top mounting
Key in position 1
System is switched off.
Key in position 2
System is switched on and ready to start.
The key cannot be pulled out in this position.
ADVICE
■
If there is visible damage to components or cables, do not turn on the
DEEP BLUE system.
■
Ensure that all people on board wear a life jacket.
■
Before starting, attach the pilot-line of the Emergency Stop to your wrist or
life jacket.
■
The charge state of the battery must be checked at intervals while on the
move.
To Next Page
Loading...
Need help?
General
