Torso Electronics T-1 - SAVING A BANK; RELOADING FROM A SAVED BANK; SELECTING A PATTERN

37
The T-1 Notebook : Reference & Guide
36
The T-1 Notebook : Reference & Guide
NOTESNOTES
▌ SAVING A BANK
1. Edited, unsaved banks will illuminate PINK ⬛ and in addition, will also
ash if the pattern if playing when holding [BANK].
2. To save a bank. Hold [CTRL] + [BANK] + [VBx], ‘x’ is the bank to save.
3. The bank and value button will ash pink indicating the bank is saved
and then turn green or white if it is the selected bank.
4. Release the buttons once save is complete.
▌ RELOADING FROM A SAVED BANK
1. Hold for 1 second, [BANK] + [VBx], where ‘x’ is the current bank to
reload and is represented by value buttons 1-16.
2. The value button will ash green.
3. The previously saved bank in the slot is reloaded.
4. All banks are reloaded if the T-1 is powered up while holding [BANK].
▌ SELECTING A PATTERN
2. Hold [PATTERN] + [VBx], where ‘x’ is the pattern to select within the
current bank. Value buttons represent patterns.
• Currently selected pattern is WHITE ⬛.
• Available empty pattern slots are DARK BLUE ⬛ and edited pattern
slots are illuminated BLUE ⬛.
• The pattern pending play is illuminated WHITE ⬛. This is often also
the currently active pattern.
3. If the sequence is playing, the new pattern will be queued to change at
the end of the current pattern. If the sequence is not playing the pattern
is simply selected for editing.
4. Once the pattern is selected release the [PATTERN] button.
Generic Setup
2
Generic Setup
2
Banks and patterns can be selected within the same process. After
selecting a bank, the pattern selection option is automatically presented.
Bank and pattern numbers are represented by the value buttons 1-16. T-1
will also auto save it’s state but it is good workow practice to manually
save when building and developing sequences.
▌ SELECTING A BANK AND PATTERN
1. Select a bank. Hold [BANK] + [VBx], where ‘x’ is the bank to select.
Banks are represented by the 16 value buttons. Keep [BANK] Held
through steps 1-3 of this process.
• Currently selected, saved bank is WHITE ⬛. If unsaved the button
may be lit Bright PINK ⬛.
• Available saved banks are GREEN ⬛ and empty bank slots are
illuminated DARK GREEN ⬛.
2. While still Holding [BANK] + [VBx], where ‘x’ is the pattern to select
within the previously selected bank. Value buttons represent patterns.
• Currently selected pattern is WHITE ⬛.
• Available empty pattern slots are DARK BLUE ⬛ and edited pattern
slots are illuminated BLUE ⬛.
• The pattern pending play is illuminated WHITE ⬛. This is often also
the currently active pattern.
3. If the sequence is playing, the new pattern will be queued to change at
the end of the current pattern. If the sequence is not playing the pattern
is simply selected for editing.
4. Once the bank and pattern is selected release the [BANK] button.