Torso Electronics T-1 - SELECTING ONE OR MORE TRACKS; SWITCHING FROM TRACK TO PULSE VIEW

57
The T-1 Notebook : Reference & Guide
56
The T-1 Notebook : Reference & Guide
NOTESNOTES
Rhythmic Patterns
3
Rhythmic Patterns
3
When multiple tracks are selected parameters can be adjusted. The
behaviour of the parameter changes is dependant on how the change is
applied. Relative editing adjusts a parameter value up or down from its
current position. Absolute editing set a denitive value for the parameter.
▌ MULTI-TRACK EDITING
1. Relative editing.
• Turn a (Knob) to adjust the parameter, relative to its current value
up or down. The parameter is affected only on selected tracks.
• Hold [PATTERN] + Turn (Knob) to adjust the parameter, relative to
its current value up or down. The parameter on all tracks is affected.
2. Absolute editing.
• With the parameter settings in view i.e. double press (Knob). Press
a [VBx] to adjust the parameter. Using the value button selection will
set an absolute value, only across selected tracks.
• Hold [PATTERN] + Double Press (Knob) + Press [VBx] to adjust the
parameter. Using the value button selection will set an absolute
value, across all tracks.
▌ SELECTING ONE OR MORE TRACKS
1. Press [BANK] to ensure the ‘home’ track view is in focus. The track view
will be shown by default at start up. Currently playing tracks will ash.
2. Select a track. Press [VBx], where ‘x’ is the value button that represents
the desired track. Example, Press [VB1] to select Track 1.
3. The selected track will illuminate:-
• ORANGE ⬛ for normal sequencer tracks.
• CYAN ⬛ for MIDI CC - Control Change tracks.
• MAGENTA ⬛ for MIDI FX tracks.
4. To toggle between the normal note sequence, MIDI CC or MIDI FX,
Hold [CTRL] + Press [VBx] where ‘x’ is the value button that represents
the desired track. The track will switch between the modes on each
button press iteration.
5. To select multiple tracks for simultaneous editing. Hold [VBx] + [VBx],
where ‘x’ is the value buttons that represents the desired tracks to
select. Example, Press [VB1] + [VB2] to select Track 1 & 2. The
selected tracks will illuminate ORANGE ⬛ or CYAN ⬛ or MAGENTA ⬛.
▌ SWITCHING FROM TRACK TO PULSE VIEW
1. Press [BANK] to ensure the ‘home’ track view is in focus. The track view
will be shown by default at start up. Currently playing tracks will ash.
2. Select a tracks pulse view. Double tap [VBx], where ‘x’ is the value
button that represents the desired track. Example, Press [VB1] to select
Track 1.
3. The view will switch from track view to the pulses sequencer view.