Torso Electronics T-1 - 3.12 Clearing Patterns and Tracks; 3.13 Copying Patterns and Tracks

73
The T-1 Notebook : Reference & Guide
72
The T-1 Notebook : Reference & Guide
NOTESNOTES
Rhythmic Patterns
3
Rhythmic Patterns
3
3.12 Clearing Patterns and Tracks
Tracks, Patterns and Parameters can be cleared and reset to a default
state. Tracks and patterns will revert to an original empty state and
parameters set to defaults. There is no ‘undo’ when clearing patterns,
tracks and parameters and it should be remembered that this is a
destructive action.
▌ CLEARING A TRACK
1. Ensure track mode is in view. Press [BANK] to return ‘home’.
2. Hold [CLEAR] + [VBx], where ‘x’ is the track to clear represented by
value buttons 1-16.
3. The track value button will ash red and its settings are cleared.
▌ CLEARING A PATTERN
1. Hold [CLEAR] + [PATTERN] + [VBx], where ‘x’ is the pattern to clear
represented by value buttons 1-16.
2. The value button for the pattern will ash red and the pattern and its
sequence data is cleared.
▌ CLEARING AN INDIVIDUAL PARAMETER SETTING
1. Hold [CLEAR] + Press (Knob), where ‘Knob’ is the parameter control to
clear represented by the rotary knobs.
2. The track value button will ash red and the parameter is reset.
3.13 Copying Patterns and Tracks
Tracks, Patterns and Parameters can be copied and pasted to another
location, essentially duplicating the settings. Copy is a secondary function
accessed with [CTRL] + [COPY]. There is no ‘undo’ when pasting patterns,
tracks and parameters and it should be remembered that this is a
destructive action overwriting any existing settings. Parameter data is held
within tracks and is therefore copied between tracks.
▌ DUPLICATING A TRACK
1. Ensure track mode is in view. Press [BANK] to return ‘home’.
2. Hold [CTRL] + [COPY] + [VBx], where ‘x’ is the track to copy,
represented by value buttons 1-16. Keep [CTRL] + [COPY] held.
3. The source value button will slowly ash GREEN ⬛.
4. While Still holding [CTRL] + [COPY], press [VBx], where ‘x’ is the
destination track to paste into, represented by value buttons 1-16.
5. The destination value button will quickly ash GREEN ⬛. The
destination will be overwritten with the copied track.
▌ DUPLICATING A PATTERN
1. Hold [CTRL] + [COPY] + [PATTERN] + [VBx], where ‘x’ is the pattern to
copy, represented by value buttons 1-16. Keep [CTRL] + [COPY] +
[PATTERN] held.
2. The source value button will slowly ash GREEN ⬛.
3. While Still holding [CTRL] + [COPY] + [PATTERN], press [VBx], where
‘x’ is the destination pattern to paste into.
4. The destination value button will quickly ash GREEN ⬛. The
destination will be overwritten with the copied pattern.