Torso Electronics T-1 - 4.13 Choke and Tail Behaviour; 4.14 Note Repeat Offset Velocity

101
The T-1 Notebook : Reference & Guide
100
The T-1 Notebook : Reference & Guide
NOTESNOTES
4.13 Choke and Tail Behaviour
The behaviour of the repeats when a new trigger occurs is governed by the
Choke or Tail options. This is set within the repeats parameter view which
can be displayed by holding or double pressing (REPEATS). Choke curtails
the repeats when a new pulse is triggered while Tail allows new repeats to
be overlaid on the existing repeats.
3 Pulses (Division 1/16
th
)
3 Pulses (Division 1/16
th
)
16 Step Pattern
16 Step Pattern
Choke Mode Behaviour - Default [VB8] On
Pulses are curtailed when a new pulse is triggered. The new triggered pulse repeats
will continue as normal unless choked by another new pulse.
Existing pulses are overlaid when a new pulse is triggered. The new triggered pulse
repeats will continue as normal along with the previous repeats.
Tail Mode Behaviour - Option [VB16] On
8 Repeats (Time 1/32
nd
)
8 Repeats (Time 1/32
nd
)
1
1
5
5
9
9
13
13
Option Command Description
Choke Mode [VB8] - Default
Each new pulse chokes the previously created repeats
from the prior pulse. Voicing style is applied to both
pulses and repeats equally.
Tail Mode [VB16]
Repeats triggered from a previous pulse are overlaid with
repeats from the new pulse. Voicing style is applied to
pulses and voicing is reset on each new pulse.
x xx x x
4.14 Note Repeat Offset Velocity
The offset and pace parameters add even more creative options in the use
of the repeater. Offset operates on the velocity level of the repeats by
generating a rising ramp up or falling ramp down of the rst set of repeats.
The velocity curves are linear but the slope and direction will be based on
the setting applied. Default position for offset will apply no velocity ramp to
the note repeats.
Offset Off
Base Velocity
Offset Off
Base Velocity
Offset Min
Shallow Slope Up
Offset Min
Shallow Slope Down
Offset Max
Steep Slope Up
Offset Max
Steep Slope Down
Offset View Mode.
The ramp will start from the current base velocity and ramp to
the maximum 127 level based on the slope selected.
The ramp will start from the base velocity and ramp to the
minimum 0 level based on the slope selected.
Offset View
Hold [CTRL] + (OFFSET).
ORANGE ⬛
Coarse Probability
Ramp Up Ramp Down
WHITE ⬛
Selected Offset
Off
Rhythmic Variation
4
Rhythmic Variation
4