145
The T-1 Notebook : Reference & Guide
144
The T-1 Notebook : Reference & Guide
NOTESNOTES
7.3 Number of Cycles
Cycles will play in order. Each parameter set will play its edited values. This
helps to create arrangements and progressions. The default starting point
is 4 cycles, but up to 16 per track are selectable and a minimum of one
cycle is possible.
▌ CHANGING NUMBER OF CYCLES
1. Select the pattern and track.
2. To view the cycle page, Hold or double tap (CYCLES).
3. This can be changed in or out of edit mode.
4. To increase the number of active cycles, Turn (CYCLES) Clockwise.
The additional cycles, up to 16, will illuminate.
5. To reduce the number of active cycles, Turn (CYCLES) Counter-
clockwise. One cycle is the minimum.
7.4 Clearing Cycles
Individual cycles and also all automation for a parameter can be cleared
and reset to an original state.
▌ CLEARING CYCLES
1. Select the pattern and track.
2. To view the cycle page, Hold or double tap (CYCLES).
3. Press [CLEAR] + Press [VBx] for the value button that represents the
cycle to clear and reset to the original value. This function operates in or
out of edit mode.
4. The selected cycle is cleared and reset to original values.
▌ CLEARING PARAMETER AUTOMATION
1. Select the pattern and track.
2. To view the cycle page, Hold or double tap (CYCLES).
3. Press [CLEAR] + Press (PARAMETER) for the parameter automation to
clear and reset. This function operates in or out of edit mode.
4. The selected parameter automation is cleared and reset to original
values. Note that some parameter resets will also affect other
parameters. For example if repeats and pitch are set to a cycle and
pitch is cleared, the repeats also will be removed. However if only
repeats are removed, pitch will stay in tact.
Cycle 1
Original
Parameters
Part 1 First Change Up
Cycle 2
Original
Parameters
Cycle 3
Parameter
Set 2
Parameter
Set 2
Cycle 4
Cycles & Random
7
Cycles & Random
7
To Next Page
Loading...
