Torso Electronics T-1 - 8.6 MIDI CC Applications; 8.7 MIDI CC Manual Knob Control

165
The T-1 Notebook : Reference & Guide
164
The T-1 Notebook : Reference & Guide
NOTESNOTES
8.7 MIDI CC Manual Knob Control
The T-1 has a pre-dened set of CC parameter numbers assigned to the
control knobs when in CC Mode. These numbers ensure the source CC
matches up with the destination CC number. The value of the control
assigned to the CC number is then dynamically applied to the equivalent
destination parameter. The default assignments are CC70 - CC83 however
these can be redened for each track.
8.6 MIDI CC Applications
Control Change mode can be used for several applications. The Shape,
Groove and Tonal knobs are pre-dened with CC assignments and can
therefore be applied to change the values. The Random control can also
apply a pseudo-random sequence. CC values can be stored in tracks which
will act as a preset patch, triggering CC changes when a new pattern and
hence track is loaded or changed.
#70
#77
#74
#81
#72
#79
#76
#83
#71
#78
#75
#82
#73
#80
Parameter
CC# and CC Value
CC# CC#CC# CC#CC# CC#CC#
Value change applied
within device operation
The CC Messages are transmitted and received across the MIDI connection
and on the MIDI Channel assigned to the track.
With a Track in CC Mode i.e. [CTRL] + [VBx],
the knobs can control dened CC# parameters
Typically CC range is 0-127 although this may differ between devices. T-1 Range is 0-127.
As well as checking the CC number, the parameter range should also be checked for the
destination device. Some parameters ranges for example may be bi-polar -64 to 63.
The parameter value sent from / to the CC#,
will be determined by the knob position.
Value sent from / to the CC#,
determined by the value button.
0 - 127
Turn (KNOB) or Hold & Turn
Relative Adjustment
Hold (KNOB) + [VBx]
Absolute Adjustment
External Device
Pre-dened T-1 Knobs send CC values CC values stored as a ‘patch’ in a track
(RANDOM)
Pseudo-Random CC sequences
MIDI & WiFi Connectivity
8
MIDI & WiFi Connectivity
8