311600XPi Series UPS Installation and Operation Manual – 60616-014
13.3 Screen: Security Passwords & Keypad
The UPS has several levels of security password available:
USER (USR) , ADMIN (ADM), and other security levels for
use by service and factory representatives.
The security level is indicated on the Security Key.
The UPS stays in a security level until a new level is entered.
For example, once the UPS is placed in the USR level, it re-
mains at that level until the security level is changed.
Login:
1. Press the Security Level key,
USR
.
2. The keypad replaces the Main screen to allow entering
the password. By default the password are set to:
User: USER
Administrator: ADMIN
3. Typing in USER in the keypad will change the security
level to User. Enter the password using the alphanumeric
keys.
4. Press Write to store the password in the UPS. If the
password is accepted the text “Successful” will display at
the bottom left of the touchpad, as shown here.
If the password entered was not accepted, the text
“Error15 – Write Function” or some similar message will in-
dicate that the password or level change was not accepted.
5. Press the QUIT key and the keypad will close and the
original display restored.
This same keypad is used for data input for
parameters in the Settings tab.
KEYPAD
On-Line
DVCOH
ASYN
Main Monitor Settings Records
12:35 PM
INV
HOME
USR
USER
2ABC
5JKL
8TUV
0-:
1./
4GHI
7PQRS
3DEF
6MNO
9WXYZ
Shift
Quit
Write
619 Change Secu. Lvl
Successful
96% 100%
13.4 Forget/Reset Password
The UPS has several levels of security password available: USER (USR) , ADMIN (ADM), and additional
security levels for use by service and factory representatives.
In the event that you forget or need to reset the ADMIN password, follow these steps:
Reset ADMIN Password:
1. Ensure the Security Level key,
USR
. , shows the unit is in USER mode.
2. If necessary, change to USER mode as shown on page 30.
3. Press the Settings tab.
4. Press the CTRL/CFG key.
5. Use the page (<< and >>) and record (< and >) keys to select Cmd 621 - Reset Admin PWD.
6. Press Reset.
7. Press Write to store the default password in the UPS. If the password is accepted the text “Successful”
will display.
To Next Page
Loading...
