SAFETY INSTRUCTION
Safety Precaution
1. An isolation transformer should be connected in the power line between the receiver and the
AC line before any service is performed on the receiver.
2. Always disconnect the power plug before any disassembling of the product. It may result in
electrical shock.
3.
back in place, such as nonmetallic control knobs, insulating covers, shields, isolation resistor-
capacitor network, etc.
4. Always keep tools, components of the product, etc away from the children, These items may
cause injury to children.
5. Depending on the model, use an isolation transformer or wear suitable gloves when servicing
with the power on, and disconnect the power plug to avoid electrical shock when replacing
parts. In some cases, alternating current is also impressed in the chassis, so electrical shock is
possible if the chassis is contacted with the power on.
6. Always use the replacement parts specified for the particular model when making repairs. The
parts used in products require special safety characteristics such as inflammability, voltage
WARNING: BEFORE SERVICING THIS CHASSIS, READ THE "SAFETY
PRECAUTION" AND "PRODUCT SAFETY NOTICE" INSTRUCTIONS BELOW.
WARNING: SERVICING SHOULD NOT BE ATTEMPTED BY ANYONE UNFAMILIAR
WITH THE NECESSARY PRECAUTIONS ON THIS RECEIVER. THE FOLLOWING
ARE THE NECESSARY PRECAUTIONS TO BE OBSERVED BEFORE SERVICING
THIS CHASSIS.
To Next Page
Loading...
