Toshiba 37XV505D - Page 166

Status Check Mode
1. Press "9" button thrice on remote control during display of adjustment menu in the service
mode.
The status of this model will be checked.
2. During Status Check, the following displays are shown.
Left side is Application and UI version information of DB software. (Only digital model.)
Right side is Firmware (Driver) version information of DB software. (Only digital model.)
(8) A/D Adjust
A/D adjustment item.
--MAIN : It's enable only in double Window model. A/D adjustment status of main picture.
--SUB : It's enable only in double Window model. A/D adjustment status of sub picture.
--COMP : Component input
--PC : PC input
--NTSC :
NTSC (60 Hz) SD signal (composite input).
--PAL : PAL (50 Hz) SD signal (composite input).
--OK : A/D adjustment set correctly.
--NG : A/D adjustment set incorrect.
-- : A/D adjustment is not needed. Because its picture format isn't used.
(9) 100 Hz FPGA Software Version
It's enable only in 100 Hz drive panel model.
(10) Memory Data Version
Version information of EEPROM.
DRMA**** means model number of EEPROM.
REV** means version of EEPROM.
(11) CD number
CD information (ascii code). : Display 4 byte data.
(12) Model Name
Model name information (ascii code). : Display 7 byte data.
(13) LCD Panel Vendor information display
The following Panel Vender (DDD) and screen size (00) and resolution (EEE) are displayed.
Example : AUO-32 (1080p) indicates that Vender is AUO and Screen Size is 32 inch and Full
HD panel.
Page
16
sur
20
ADJUSTMENT [LCD Color Television] ASIA_EU
16/07/2010
file://C:\Documents and Settings\Serge\Bureau\toshiba_37xv505d
-
02_[ET]\37XV505
...