Turning the TV on
Switching on the TV
Connect the power cord to a wall outlet, the
! power indicator lights in red (standby mode).
1 Press 1 on the remote control or ! on the TV
left side panel, the ! power indicator lights
in green.
NOTE:
If you watch black and white programmes when the
Colour System mode is set to “A” (Automatic), colour
noise may appear on the screen. In this case select the
appropriate Colour System (For the system of each
country or region, refer to pages 11, 29).
Switching o the TV
1 Press 1 on the remote control or ! on the TV
left side panel to switch to the standby mode.
NOTE:
• When the TV will not be used for a long period of
time, such as during vacation or travel, remove the
power plug from the wall outlet.
• The TV will automatically turn o in 15 minutes
based on No Signal Power Down settings (-
page 18) if no signal is detected.
The TV will automatically turn itself o after
approximately 2 hours if you do not operate the TV
after turned on by on timer function.
• If power is cut o while you are viewing the TV,
the Last Mode Memory function turns on the TV
automatically when power is applied again. If power
is going to be o for a long time and you are going
to be away from your TV, unplug the power cord to
prevent the TV from turning on in your absence.
Tuning the TV for the rst time
Before switching on the TV, put your decoder and
media recorder to standby, if they are connected,
and ensure that the aerial is connected. To setup
the TV, use the buttons on the remote control as
detailed on page 8.
1 Press the 1 button. The Quick Setup screen
will appear. This screen will appear the rst time
that the TV is switched on.
Quick Setup
Menu Language English
2 Press or to select the menu language.
3 Press OK, to display the Location menu.
Press or to select Store or Home. For
normal home use, select Home.
You can select either Home or Store mode.
Home is recommended for normal home use.
Select Store when using a TV for displaying in
a shop, etc.
Location
Home
To use the TV for displaying in a store showroom, please select
[Store]. [Home] mode is recommended for normal use.
Store mode:
• A con rmation menu will appear.
• Intelligent Auto View (or AutoView :
32P2400 Series / 32L2400 Series) menu is not
available.
4 Press OK to display the Intelligent Auto View
(or AutoView : 32P2400 Series / 32L2400 Series)
menu (- page 15).
Press or to select Ye s or No.
• When you select No, skip to step 5.
5 Press OK to display the Ambient Type menu.
Press or to select Fluorescent Light or
Light Bulb.
• Set the ambient light environment to help
Intelligent Auto View (or AutoView :
32P2400 Series / 32L2400 Series) function
more e ectively (- page 16).
Ambient Type
Flourescent Light
To use the TV under the bluish lighting environment,
please select [Flourescent Light].
To use the TV under the orangish lighting
environment, please select [Light Bulb].
6 Press OK to display the Auto Tuning menu, and
then or to select On or O .
Auto Tuning
Auto Signal Booster
Start Scan
On
7 Select Start Scan and press OK to start the
automatic search.
Auto Tuning
1% 0
Progress Found
When the automatic search is completed,
the TV will automatically appear the Manual
Tuning menu.
– 10 –
To Next Page
Loading...
