Toshiba 40L2400 Series - Audio Adjustment Features; Sound Quality and Effects

Selecting the stereo programmes
When a stereo programme is received, d Stereo
appears and press
s
.
• Use the modes: Stereo and Mono
Selecting the monaural programmes
If sound distortion, interruptions or silence arises in
the low sound volume level, setting the e Mono 2
mode will mitigate the problem.
When a monaural programme is received, e Mono
appears and press
s
.
• Use the modes: Mono 1 and Mono 2
NOTE:
On some cases, the reception of stereo/bilingual
broadcasts may not be possible after switching on the
e Mono 2 mode.
Adjusting the sound Balance
• Use the menu: SOUND and Balance
• Use the button:  and 
Using the Sound Mode
Choose your preferred Sound Mode.
• Use the menu: SOUND, Advanced Sound
Settings
• Use the item: Sound Mode
• Use the modes: Dynamic, Natural and Clear
Voice
NOTE:
You can also press
on the remote control to switch
Sound Mode.
Adjusting the sound quality
You can adjust the basic sound quality.
• Use the menu: SOUND and Advanced Sound
Settings
• Use the items: Bass and Treble
• Use the button:  and 
Using the Surround
Surround help to create rich and wider sound from
stereo sound sources.
• Use the menu: SOUND, Advanced Sound
Settings and Surround
• Use the modes: On or O .
Using the Power Bass Booster
Power Bass Booster helps to create rich bass.
• Use the menu: SOUND, Advanced Sound
Settings
• Use the item: Power Bass Booster
• Use the modes: Super, Normal and O
NOTE:
This may not have an e ect, depending on the audio
source.
Resetting the Advanced Sound Settings
• Use the menus: SOUND, Advanced Sound
Settings and Reset
• Use the item: Reset (select Ye s and press OK)
Using the Dynamic Range Control
This feature allows control of compression for Dolby
Digital.
• Use the menu: SOUND
• Use the item: Dynamic Range Control
Using the Audio Distortion Control
Prevents audio distortion.
• Use the menu: SOUND
• Use the item: Audio Distortion Control
• Use the modes: On and O
Using the Audio Level O set
Sometimes there can be large changes in volume
when switching from an ATV channel or an external
input. Using this feature reduces these volume
di erences.
• Use the menu: SOUND
• Use the item: Audio Level O set
• Use the button:  and 
Using the Spectrum Analyser
Shows sound in a visual format.
• Use the menus: SOUND
• Use the item: Spectrum Analyser
NOTE:
The Spectrum Analyser display turns o when any
other procedure is performed.
– 17 –