Toshiba 40L365 Series - Turning the Tv
For
The
Rst Time; Selecting the External Input Source to View

7 When the search is complete, it will switch to
the rst channel.
3 Display the Location menu.
Before switching on the TV, put your decoder and
media recorder to standby, if they are connected,
and ensure that the aerial is connected. To setup
the TV, use the buttons on the remote control.
Tuning the TV for the rst time
Press or to select Store or Home.
You can select either Home or Store mode.
Home is recommended for normal home use.
Select Store when using a TV for displaying in
a shop, etc.
5 Press , , or to select the country and
press OK.
2 Press , , or to select the OSD
language, and then press OK.
6 Input the EWS Local Postal Codes and start
the Channel Tuning.
The television will start to search for available
ATV/DTV or Radio channels. The progress
bar will indicate the scan status.
You must allow the television to complete
the search.
1 Press the button. The Please select an OSD
language screen will appear. This screen will
appear the rst time that the TV is switched
on.
4 Press OK to display the DVB Select type.
Press or to select DVB-Tor DVB-C.
Introduction / Getting started
Selecting the external input source to view
1 Press on the remote control until the
external input mode list appears on the screen,
then press , or to select appropriate
input source.
2 Press OK.
NOTE:
If the Inputs list is displayed by pressing and
or on the right side of the TV .The options as
follows.
• DTV/ATV/AV/HDMI/MHL/PC/USB.
(24L365*)
• DTV/ATV/AV/HDMI1/MHL/HDMI2/PC/USB.
(32/40/43/49L365*)
• DTV/ATV/AV/HDMI1/MHL/HDMI2/HDMI3/PC/
USB.(55L365*)
Input Source
17